Glowshift 7 Color Series Clock Gauge Manual de usuario descargar pdf

7 Color Series Clock Gauge

For Product Numbers: GS-C718, GS-T718 and GS-W718

Wire Color Code

Yellow:

12v Constant Source (+) (un-switched)

Black:

Vehicle Ground ( - )

Red:

12v Ignition Source (+) (switched)

Orange:

12v Switched Headlamp Source (+) (optional)

1. Disconnect the vehicle's negative battery cable.

Connecting the Power Wire Harness

2. To make the wiring of your gauges easier you can

purchase an expandable circuit. This component easily fits

into your fuse panel and provides an additional fused power

wire for accessories such as gauges. The expandable circuit

is available for purchase at www.GlowShift.com.

3. Using automotive grade wiring (18 gauge), connect the

yellow wire to a positive 12 volt constant (un-switched)

source either on the vehicle or in the fuse box.

 Note: If you are connecting the yellow wire

directly to the battery, you MUST install a 3 amp

fuse within 6-8 inches of the battery connection.

4. Using automotive grade wiring (18 gauge); connect the

red wire to a positive 12 volt ignition (switched) source. It

may be connected to the fuse panel, an accessory wire, or

any positive 12 volt source that turns on and off with the

ignition.

5. Using automotive grade wiring (18 gauge); connect the

black wire to any good (unpainted) ground connection. You

may also route a wire directly to the negative side of the

vehicle’s battery.

6. The Night Time Dimming feature decreases the

brightness of the gauge face by 30%. Connect the orange

wire to the 12 volt positive headlamp source. This allows the

mode to be activated when the headlights come on. This step

is optional and will not affect operation of the gauge if it is

omitted.

 Note: Do not connect the orange wire to a dimmer

wheel. This will cause the gauge lighting to flicker.

7. Reconnect the vehicle's negative battery cable.

 If your gauge(s) do not illuminate or do not recall

your last saved color, your switched and un-switched

sources are reversed.

 If your gauge(s) only illuminate red then the yellow

wire for constant source is not connected properly.

 Be sure all of your wiring is correct to ensure proper

gauge operation.

Setting the Time on the Clock

8. Press and hold the button located on the gauge face until

the needle starts to flash. Release the button once it is

flashing, then press and hold the button again to set the clock

to the appropriate time. Once the clock is set, release the

button.

1 2 3

7 Color Series Clock Gauge 1

Indice de contenidos

Pagina 1 - 7 Color Series Clock Gauge

7 Color Series Clock Gauge For Product Numbers: GS-C718, GS-T718 and GS-W718 Wire Color Code Yellow: 12v Constant Source (+) (un-switched) Black:

Pagina 2

Additional Installation Information & Material Requirements  GlowShift Gauges Approved Conductor Wires: Successfully installing GlowShift Gaug

Pagina 3

3. EXCEPTIONS TO LIMITED WARRANTY: GlowShift shall have no obligation to Purchaser with respect to any Product that is subjected to any of the fol

Modelos relacionados Clock Gauge

Comentarios a estos manuales

Sin comentarios

Glowshift 7 Color Series Clock Gauge Manual de usuario

Busca en linea o descarga Manual de usuario para Para El Coche Glowshift 7 Color Series Clock Gauge. GlowShift 7 Color Series Clock Gauge User Manual Manual de usuario

Indice de contenidos

Modelos relacionados Clock Gauge

Comentarios a estos manuales

Relacionado con productos y manuales para Para El Coche Glowshift 7 Color Series Clock Gauge